GF 116 is a double-coated pressure sensitive 1.0 mil clear polyester film with a high-tack permanent adhesive on one side and a high-tack removable adhesive on the other side. GF 116 has a 4.5 mil clear air egress PET liner printed with Remove to Expose Adhesive on the removable adhesive side. This air egress liner assures smooth bubble free application (NOTE: Air-Egress adhesives are DRY APPLY ONLY). The clear liner allows the graphics to be viewed after lamination with GF 116. This product is designed for laminating thin flexible plastic films and papers commonly found in graphics for temporary application to glass. The high-tack permanent HTAP adhesive is protected by a 1.5 mil clear polyester liner. This clear mounting film can be laminated by the cold laminating process without the addition of heat.
GF 116-54
GF 116 is a double-coated pressure sensitive 1.0 mil clear polyester film with a high-tack permanent adhesive on one side and a
high-tack removable adhesive on the other side. G
Technical Specification
Applications | Concept® 116 is designed to produce two sided decals using digital prints, screen printed and other printed images for application to glass. These decals are cleanly removable. In all cases the substrates must be clean and free of dust, dirt and oil. This product is not recommended for tinted or laminated windows. May be used on substrates other than glass but your specific application must be thoroughly tested before production. Concept® 116 is intended for graphic film and paper laminations and it is not a structural mounting tape. |
Thickness | Carrier Film: 0.9 to 1.0 mils Adhesive: 0.8 to 1.0 mils each side. AP Liner: 1.4 to 1.6 mils Air Egress Liner: 4.4 to 4.8 mils. (Thickness variance +/- 10%) |
Dimensional Stability | Good |
Temperature Ranges | Minimum application temperature: +40° F Service temperature range: -40°F to +180°F. |
Exterior Applications | Removability of 200-4999 adhesive from standard window glass is up to 6 months under normal exposure conditions. |
Adhesion | Removable Adhesive (AP adhesive laminated to 2-mil polyester film before adhesion testing) To glass 12 to 40 oz. / in. To standard test panels 12 to 40 oz. / in. When tested according to PSTC-101 Method A with a 24-hr. dwell at 70°F and 50% relative humidity. Typical values. Individual values may vary. Test thoroughly before production. |
Storage Stability | One (1) year shelf life when stored at 70°F and 50% relative humidity. |
Product Code | Concept® 116-54 (54” X 150’ Roll) |
Recomendations | Completely evaporate inkjet solvents before laminating mounting film. Failure to do so may facilitate solvent penetration resulting in vinyl degradation. |
Additional information
Weight | 42 lbs |
---|---|
Dimensions | 57 × 7 × 7 in |
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.